Furnace Repair in Wethersfield, CT
A furnace that is acting up rarely fixes itself. Call us for furnace repair in Wethersfield, CT and a technician will diagnose it, quote the fix before starting and use parts matched to your model.
- Upfront quote before work
- 90-day parts & labor warranty
- Parts matched to your model
- Same-day service when available
How we repair your Furnace
A furnace heats air with a gas burner or electric elements and a heat exchanger, then a blower pushes the warm air through the ductwork to the rooms. A furnace relies on a heat source, safety controls such as limit switches and flame sensors, blowers or circulator pumps, and a thermostat. A technician checks the ignition and safety sequence, airflow or water flow, and electrical controls.
Furnace repair at a glance
- Typical repair cost$150–$650
- Typical service life15–25 years
- Warranty on repairs90 days parts & labor
- QuoteUpfront, before work
- Same-day visitsWhen available
Common Furnace problems we fix
What usually causes each symptom, and what our technician checks to confirm it.
Furnace not igniting
- Likely causes
- A cracked hot surface igniter, a failed pressure switch or inducer motor, a closed gas valve, or a control board fault.
- What our technician checks
- The technician reads the board fault code, tests the igniter resistance, and checks inducer operation and pressure switch closure.
Carbon monoxide alarm or soot
- Likely causes
- A cracked heat exchanger, a blocked flue or vent, or incorrect combustion air.
- What our technician checks
- Combustion is analyzed for carbon monoxide, the heat exchanger is inspected with a camera, and venting is checked for blockage.
Burners light then shut off
- Likely causes
- A dirty flame sensor, a poor ground, or a cracked or misaligned burner that does not carry flame to the sensor.
- What our technician checks
- Flame sensor microamps are measured, the sensor is cleaned, and burner alignment and ground are checked.
Loud bang or rumble at startup
- Likely causes
- Delayed ignition from dirty burners, low gas pressure, or a weak igniter.
- What our technician checks
- Burners are cleaned, inlet and manifold gas pressure are measured, and ignition timing is observed.
Blower runs constantly
- Likely causes
- A thermostat fan setting, a stuck relay on the control board, or a limit switch held open by overheating.
- What our technician checks
- The thermostat and board relay are tested and limit switch status is verified.
Blowing cold air
- Likely causes
- A tripped high-limit switch from a clogged filter, a failed gas valve, or a thermostat fan set to on.
- What our technician checks
- Temperature rise and static pressure are measured, the limit switch is tested, and gas valve voltage is checked.
Quick checks you can do safely
- Set the thermostat to heat and above room temperature, and replace its batteries.
- Replace a dirty air filter.
- Make sure the furnace power switch and breaker are on.
- Check that the front panel is fully closed so the door switch engages.
- Clear snow or debris from outdoor intake and exhaust pipes on high-efficiency units.
Safety first: Gas furnaces can leak gas or carbon monoxide; if you smell gas or a CO alarm sounds, leave the house and call the gas utility or 911.
Still not working?
Call and describe what you see and hear, plus any error code. It helps the technician bring the right parts on the first visit.
(844) 442-1999Seeing a code? Try our error code lookup or troubleshooting wizard.
Our 5-step furnace repair process
- Call or book onlineTell us the appliance, brand and what it is doing. We confirm a visit window that works for you.
- DiagnosisThe technician inspects and tests the furnace to find the actual cause, not just the symptom.
- Upfront quoteYou get a clear price before any work starts. No surprise charges.
- RepairWe fix it with parts matched to your model, often on the same visit when the part is on the truck.
- Test and warrantyWe test the unit under normal operation, clean up and back the repair with a 90-day parts-and-labor warranty.
Furnace repair cost and lifespan
National ballpark estimates. Your exact price depends on the part and labor, and you get it upfront after diagnosis. On the fence? Try the repair vs replace calculator.
Parts we replace most often
- Hot surface igniter
- Flame sensor
- Inducer motor
- Pressure switch
- Blower motor
- Gas valve
- Control board
We match every part to your model and serial number.
Keep your Furnace running longer
- Keep the condensate drain clear on high-efficiency models.
- Keep the area around the furnace clear of storage and chemicals.
- Install and test carbon monoxide detectors near sleeping areas.
- Schedule a professional inspection before each heating season.
- Change the filter every one to three months.
Build a maintenance plan
Create a printable monthly, quarterly and yearly checklist for every appliance in your home.
Open the schedule generatorFurnace repair in Wethersfield, CT
Long winters and humid summers in Connecticut keep dryers, ovens and refrigerators in Wethersfield busy all year.
We provide furnace repair throughout Wethersfield, including ZIP codes 06109 and 06129, and in nearby Newington, Hartford and West Hartford.
In coastal parts of Connecticut, salt air speeds up corrosion on coils, burners, fasteners and electrical connections, especially on equipment installed outdoors.
Frequently Asked Questions
How much does furnace repair cost in Wethersfield, CT?
Most furnace repairs fall roughly between $150 and $650, depending on the part and labor involved. That is a national ballpark estimate; you get an exact quote after diagnosis and before any work starts.
Can you repair my furnace the same day?
Often, yes. Call (844) 442-1999 early in the day and we will try to schedule a same-day visit. Same-day service depends on technician availability and whether the part is in stock.
Is the repair guaranteed?
Yes. Completed repairs are covered by a 90-day parts-and-labor warranty. If the same problem comes back in that time, we come back and fix it.
Which brands do you service?
We work on all major brands, including American Standard, Armstrong Air, Bryant, Carrier, Goodman and Lennox.
Should I repair or replace my furnace?
A typical furnace lasts about 15 to 25 years. If yours is well within that range and the repair costs less than half the price of a new one, repair is usually the better value. Our technician will tell you honestly if replacement makes more sense.
Other heating equipment repairs
- Infrared Heater Repair
- Heat Pump Repair
- Wall Heater Repair
- Baseboard Heater Repair
- Space Heater Repair
- Radiant Floor Heating System Repair
- Geothermal Heat Pump Repair
- Patio Heater Repair
- Ductless Mini-Split Heat Pump Repair
- Boiler Repair
More repair services
- Refrigerator Repair
- Washing Machine Repair
- Dryer Repair
- Dishwasher Repair
- Oven Repair
- Range Repair
- Microwave Repair
- Ice Maker Repair
- Brita Water Filtration System Repair
- Hamilton Beach Water Boiler Repair
- Server Products Juice Dispenser Repair
- Wolf Range Hood Repair
- Samsung Top/Bottom Mount Fridge Repair
- Globe Spiral Mixer Repair
Get your furnace fixed in Wethersfield
Upfront quote before work starts · Parts matched to your model · 90-day warranty